Issue 3, 2014

From lab to fab: how must the polymer solar cell materials design change? – an industrial perspective

Abstract

Organic photovoltaic (OPV) devices, in particular polymer solar cells, made by solution processed organic materials have shown great promise as a disruptive technology for affordable electricity. Even though recent advances look impressive on paper, until now the commercialization of OPV has been hampered by the difficulty of converting lab produced “champion” cell figures into reliable industrial-scale product performances. A key factor to achieve this condition is to develop OPV materials (polymer donors, acceptors, buffer materials, electrodes materials and encapsulants) exhibiting the required technical and economic characteristics to be conveniently used in an industrial environment. The well established strategies for the design of materials for efficient lab-scale OPV devices are not sufficient when large-area printed panels are concerned. A number of additional requirements, normally not addressed in the laboratory context, must be met: the materials must be easily accessible as pure compounds in few synthetic steps from cheap starting compounds, need to be stable and soluble enough to afford ink formulations processable with roll-to-roll compatible equipment; solvent and solvent additives should be easily removable after printing, and possibly should be environmentally friendly compounds; the layers should achieve a stable morphology under mild conditions (low temperatures and short times); the above mentioned materials can be screened on glass substrates, but should be finally tested on plastic films, protected through a scalable encapsulation technique. The more researchers adhere to these guidelines, the greater the possibility for OPV to demonstrate at last its enormous potential on the industrial scale.

Graphical abstract: From lab to fab: how must the polymer solar cell materials design change? – an industrial perspective

Supplementary files

Article information

Article type
Perspective
Submitted
17 Oct 2013
Accepted
02 Dec 2013
First published
09 Dec 2013

Energy Environ. Sci., 2014,7, 925-943

From lab to fab: how must the polymer solar cell materials design change? – an industrial perspective

R. Po, A. Bernardi, A. Calabrese, C. Carbonera, G. Corso and A. Pellegrino, Energy Environ. Sci., 2014, 7, 925 DOI: 10.1039/C3EE43460E

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements