Issue 6, 2000

Abstract

Trace element analysis of snow samples was performed by inductively coupled plasma sector field mass spectrometry (ICP-SFMS) using ultrasonic nebulization. The mass resolution was set to 3500 in order to use the ability of the high resolution technique to resolve most spectral interferences from the analyte ions. By setting the nebulizer gas pressure at 10 psi, a sensitivity improvement factor of around 40 was observed using the ultrasonic nebulizer in comparison with the standard Meinhard concentric nebulizer. Under these conditions, the sensitivity was 100 MHz per ppm of indium at a mass resolution of 3500, which corresponds to 1 GHz at a resolution of 500. Measurement repeatabilities expressed in terms of RSD were better than 5%, depending on the element. The accuracy of the method was demonstrated by results from runs of certified riverine water reference material SLRS-3 (National Research Council Canada). Trace metal concentrations quantified after analysing calibration standards were measured in snow samples. The detection limits obtained for trace metals in the high resolution mode without the influence of signal interferences were 0.26, 1.4, 0.52, 0.01 ng l-1 for 55Mn, 58Ni, 63Cu and 238U, respectively.

Article information

Article type
Inter-laboratory Note
Submitted
17 Jan 2000
Accepted
04 Apr 2000
First published
28 Apr 2000

J. Anal. At. Spectrom., 2000,15, 731-734

Determination of ultra-trace elements in snow samples by inductively coupled plasma source sector field mass spectrometry using ultrasonic nebulization

M. Bensimon, J. Bourquin and A. Parriaux, J. Anal. At. Spectrom., 2000, 15, 731 DOI: 10.1039/B000460J

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements