Issue 12, 2003

Separation of plutonium from soil and sediment prior to determination by inductively coupled plasma mass spectrometry

Abstract

The purpose of this work was to develop an optimised sample-preparation procedure for the determination of Pu in soil/sediment with ICP-MS. To start with, several different procedures were screened for their ability to separate plutonium and remove uranium. After the screening, two methods were applied on one soil (IAEA Soil6) and two sediment reference materials (IAEA300 and IAEA135). These methods were based on separation of Pu using TEVA and a combination of UTEVA and TRU resins, followed by elution of Pu with 0.1% hydroxylethylidene diphosphonic acid (HEDPA). A comparison was also made between sample preparation based on acid-leaching and complete digestion using lithium borate fusion. The highest yield of Pu (80%) was found with the procedure consisting of fusion followed by TEVA, while the decontamination from U showed large variations (RSD varying from 16–52%) with all procedures. No difference in the recovery of Pu was found between the two sample preparation techniques. The results of the quantitative determination in low resolution of 239Pu and 240Pu from the UTEVA + TRU-separation were significantly higher than those obtained by the TEVA procedure. An analysis in higher mass resolution displayed interfering peaks in the mass-region of Pu, and lanthanide-containing polyatomic ions were found to be a likely cause for these interferences. The procedure based on lithium borate fusion and separation using the TEVA-resin avoided such interferences and was therefore tested for repeatability over time on IAEA300. The stability of the method was good (RSD = 2.49% (n = 8)), with the exception of one value being significantly higher than the others. This result was confirmed by analysis in higher mass-resolution, which indicates an inhomogeneous distribution of Pu in the reference material, despite a sample intake of about 1 g.

Article information

Article type
Paper
Submitted
11 Jun 2003
Accepted
20 Oct 2003
First published
14 Nov 2003

J. Anal. At. Spectrom., 2003,18, 1426-1434

Separation of plutonium from soil and sediment prior to determination by inductively coupled plasma mass spectrometry

U. Nygren, I. Rodushkin, C. Nilsson and D. C. Baxter, J. Anal. At. Spectrom., 2003, 18, 1426 DOI: 10.1039/B306357G

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements