Issue 12, 2016

An investigation on the influence of support type for Ni catalysed vapour phase hydrogenation of aqueous levulinic acid to γ-valerolactone

Abstract

Ni (20 wt%) supported on SiO2, γ-Al2O3 and ZrO2 catalysts was examined for hydrogenation of aqueous levulinic acid (LA) to γ-valerolactone (GVL) at 270 °C and ambient pressure. The band intensities of Brønsted (BAS: 1540 cm−1) and Lewis acid sites (LAS: 1450 cm−1) estimated by pyridine adsorbed DRIFT spectra revealed a lower ratio of BAS/LAS over the Ni/SiO2 catalyst than over the Ni/ZrO2 and Ni/γ-Al2O3 catalysts. The rate of angelica lactone (AL) formation was lower than the rate of AL hydrogenation over the Ni/SiO2 catalyst. The poisoning and regeneration of the Ni/SiO2 catalyst using pyridine and 2,6-dimethylpyridine demonstrated that Lewis acid sites influenced the conversion of LA to AL and subsequent hydrogenation of AL to GVL occurred on surface Ni sites. In contrast, Brønsted acid sites were responsible for the ring opening of GVL to valeric acid (VA). Kinetic data emphasized that the hydrogenation activity and product distribution were dependent on the type of acid site, and the Ni sites in close proximity to Brønsted acid sites are prone to hydrogenolysis of GVL to valeric acid and hydrocarbons.

Graphical abstract: An investigation on the influence of support type for Ni catalysed vapour phase hydrogenation of aqueous levulinic acid to γ-valerolactone

Supplementary files

Article information

Article type
Paper
Submitted
16 Nov 2015
Accepted
07 Jan 2016
First published
12 Jan 2016

RSC Adv., 2016,6, 9872-9879

Author version available

An investigation on the influence of support type for Ni catalysed vapour phase hydrogenation of aqueous levulinic acid to γ-valerolactone

V. V. Kumar, G. Naresh, M. Sudhakar, C. Anjaneyulu, S. K. Bhargava, J. Tardio, V. K. Reddy, A. H. Padmasri and A. Venugopal, RSC Adv., 2016, 6, 9872 DOI: 10.1039/C5RA24199E

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements