Issue 45, 2018

A vertical WSe2–MoSe2 p–n heterostructure with tunable gate rectification

Abstract

Here, we report the synthesis of a vertical MoSe2/WSe2 p–n heterostructure using a sputtering-CVD method. Unlike the conventional CVD method, this method produced a continuous MoSe2/WSe2 p–n heterostructure. WSe2 and MoSe2 back-gated field effect transistors (FETs) exhibited good gate modulation behavior, and high hole and electron mobilities of ∼2.2 and ∼15.1 cm2 V−1 s−1, respectively. The fabricated vertical MoSe2/WSe2 p–n diode showed rectifying IV behavior with back-gate tunability. The rectification ratio of the diode was increased with increasing gate voltage, and was increased from ∼18 to ∼1600 as the gate bias increased from −40 V to +40 V. This is attributed to the fact that the barrier height between p-WSe2 and n-MoSe2 is modulated due to the back-gate bias. The rectification ratio is higher than the previously reported values for the TMDC p–n heterostructure grown by CVD.

Graphical abstract: A vertical WSe2–MoSe2 p–n heterostructure with tunable gate rectification

Associated articles

Supplementary files

Article information

Article type
Paper
Submitted
20 Apr 2018
Accepted
04 Jul 2018
First published
17 Jul 2018
This article is Open Access
Creative Commons BY-NC license

RSC Adv., 2018,8, 25514-25518

A vertical WSe2–MoSe2 p–n heterostructure with tunable gate rectification

H. Liu, S. Hussain, A. Ali, B. A. Naqvi, D. Vikraman, W. Jeong, W. Song, K. An and J. Jung, RSC Adv., 2018, 8, 25514 DOI: 10.1039/C8RA03398F

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements