Issue 4, 1981

Photoelectrochemistry of nickel(II) oxide

Abstract

The electrochemistry and photoelectrochemistry of a (110) face of single-crystal lithiated NiO has been studied. The Mott–Schottky and photocurrent appearance potential suggest a flat-band potential of +0.8 V (NHE), and earlier capacitance data are used to fix a second acceptor level at +0.4 eV above the Li acceptor states. A simple geometrical interpretation of the anodic transients at 0.95 and 1.30 V (NHE) is provided, and the Tafel slope observed at anodic potentials is shown to be consistent with an electrochemical process having charge transfer as a rate-determining step. The optical data are interpreted with an energy-level scheme using a value of ca. 3 eV for the Hubbard parameter U defining the correlation splitting of the Ni 3d8 and Ni 3d9 configurations, and the data are consistent with a direct allowed transition at the band edge that is assigned to O 2p6→ Ni 3d9. Comparison with the X.p.e.s. spectrum and the known position of the O 2p6 band edge in other transition-metal oxides leads to a suggested Ni 3d8–O 2p6 band-edge separation of ca. 1.4 eV. The very low efficiencies found for NiO can be understood only if the minority-carrier diffusion length becomes comparable with the semiconductor Debye length. The very low ratio of free carriers to trapped holes in NiO is shown to make this material impractical for solar-energy devices.

Article information

Article type
Paper

J. Chem. Soc., Faraday Trans. 2, 1981,77, 643-661

Photoelectrochemistry of nickel(II) oxide

M. P. Dare-Edwards, J. B. Goodenough, A. Hamnett and N. D. Nicholson, J. Chem. Soc., Faraday Trans. 2, 1981, 77, 643 DOI: 10.1039/F29817700643

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements