Issue 5, 1995

Surface chemistry of silica–titania-supported chromium oxide catalysts

Abstract

The interaction of chromium oxide with different titania–silica supports has been examined. The oxide supports investigated consisted of SiO2, TiO2, physical mixtures of TiO2 and SiO2, a surface titania overlayer on SiO2(10% of theoretical monolayer) and a surface silica overlayer on TiO2(80% of theoretical monolayer). The supported chromium oxide catalysts were structurally characterized with Raman spectroscopy (RS), diffuse reflectance spectroscopy (DRS) and electron paramagnetic resonance (EPR) and chemically probed by the methanol oxidation reaction. The RS and DRS characterization studies demonstrate that the supported chromium oxide phase is almost exclusively present as a surface Cr6+ overlayer for 1–3% CrO3, but traces of Cr3+ and Cr5+ are also detected. Under ambient conditions, the molecular structures of the surface chromates (monochromates vs. polychromates) are dependent on the net pH at the point of zero charge of the thin aqueous film at the surface of the supports. Under dehydrated conditions, the molecular structures are dependent on the specific support and its composition. Monochromates are dominant on SiO2 and the surface silica overlayer on TiO2. Both polychromates and monochromates are present on the surface titania overlayer on SiO2, while surface polychromates are primarily present on TiO2 as well as the TiO2 and SiO2 physical mixtures. These physical mixtures possess mainly polychromates because Cr6+ and Cr5+ preferentially migrate and coordinate to the titania phase. The surface chromate and Cr5+ species also appear to coordinate preferentially to the surface titania sites present in the surface titania overlayer on SiO2. The methanol oxidation probe reaction could not readily discriminate between the different surface chromate coordination sites because of the very similar reactivity and selectivity patterns of all the different surface sites present in the supported chromium oxide catalysts. The reactivity patterns, however, are consistent with the coordination of Cr oxide to the surface titania sites on SiO2.

Article information

Article type
Paper

J. Chem. Soc., Faraday Trans., 1995,91, 953-961

Surface chemistry of silica–titania-supported chromium oxide catalysts

J. Jehng, I. E. Wachs, B. M. Weckhuysen and R. A. Schoonheydt, J. Chem. Soc., Faraday Trans., 1995, 91, 953 DOI: 10.1039/FT9959100953

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements